- Pre-sales : +86 13864358661
Shandong Hairui Zhonglian Pump Industry Co. , ltd. The conduit pump that is a major produces manufacturer. When type selecting of client conduit pump, manufacturer of my company water pump can provide the before-sales service such as price of pump of conduit pump model, conduit, in order to offer client reference, and manufacturer of my water pump can provide the service of product of custom-built pump industry for the client. This product information is about horizontal conduit pump searchs, the knowledge that looks for elevation, make level and hoisting:
The measurement of pump of 1. horizontal conduit and adjust
The measurement of pump housing and adjust include to search, seek elevation and make level 3 respects.
1) is searching namely the line of vertical, horizontal center of pump housing. The fore-and-aft center line of pump housing is with pump shaft center the line is accurate; Transverse center line allows with exporting central line of the canal to be. Searching when, should according to the equipment center line that already had held (or the central line of foundation and fence post) will undertake measure and be adjustmented, make the line of vertical, horizontal center of pump housing accords with the requirement of blueprint, join well with other equipment. The line of vertical, horizontal center of pump housing is by blueprint permissible variation in dimension person in 5mm limits.
2) seeks level, Conduit pumpelevation is the central line with pump shaft to allow. When seeking level, undertake metrical commonly with sruveyor’s level. When measuring, put surveyor’s pole on the datum mark that sets inside workshop, measure the lens heart height that gives sruveyor’s level, move surveyor’s pole to go up to journal next, measure a meridional plane interval to lens heart, can give the level of line of pump shaft center by formulary computation next.
After the central line position of pump housing of 3) make level and elevation had searched, begin to adjust the level of pump housing, use the square gradienter of precision 0.05mm/m above all, in pump housing around aspirant travel measures the journal of two end. When adjusting a level, can raise in pump housing add between foot and baseplate decrease weak iron sheet to adjust. The horizontal tolerance of pump housing is 0.3-0.5mm/m commonly.
The hoisting of pump of 2. horizontal conduit
To small-sized conduit pump, usable 2~4 person is raised put to base. To medium-sized conduit pump, can use haul wearing and the method that roll bar to roll on oblique plane to carry and be installed. To large and medium-sized conduit pump, can use rise to be worn again undertake hoisting, also use Chan Mu to remove heavy lever and other block matched stack to close to undertake hoisting sometimes. In addition, still can use factory building inside or the original lifting appliance on the foundation (wait like bridge crane, dynamoelectric calabash) horizontalConduit pumpDirect hoisting arrives on the foundation. When hoisting, answer to bind sling the bottom in pump housing, must not bind go up in axis or bearing.
Thank you very much to Shandong Hairui Zhonglian Pump Industry Co. , ltd. The visit of official website! Above is about horizontal conduit pump searchs, the introduction that looks for elevation, make level and hoisting, still think to this problem like you deep one pace understanding, or the problem that has price of model of type selecting of product of other pump industry, water pump, water pump, water pump needs to solve, contact this water pump manufacturer please, my company returns production to suck pump oneself, welcome you at any time seek advice.
